Craftsman SP5373 Motor, Excessive dust fin tO could cause excessive heat, Filter/dust bag and!or

MOTOR :

Excessive dust fin _tO_: could cause excessive heat: in

motor.:

Every effort shou!d be imade _to:prevent foreign material fromenteting the motor:i When operated ur_ler condi- tions likely to permit accumtllations of dust, dirt;or waste within the motor, a visual inspection should be made at frequent intervals. Accumulations of dry dust can usu- ally be blown out successfully.

NOTE: Motors used on wood-working tools are particu- larly susceptible to the accumulation of sawdust and wood chips and should be blown out or "vacuumed"

frequently to prevent interference with normal motor ventilation.

To remove dust, blow off motor with a low pressure air hose.

_CAUTION: To avoid eye Injury or adverse

reaction to dust, high air pressure should not be used especially In poorly ventilated areas.

The operator performing this cleaning function should wear safety goggles and filter mask

Do not use unit if power cord becomes worn or frayed.

If any servicing (other than the above cleaning) be- comes necessary, it should be performed by an author- ized Sears Service Center.

NOTE: The speed of this motor cannot be regulated or changed.

troubleshootinq

MOTOR

PROBLEM.1 PROBABLE CAUSE

• _• •. •.: •• •• - •,•1,••• • • •

Excessive	sawdust	1.	Loose	connectors
in air.		2.	Filter/dust bag and!or
			chip collection bag
			releasing sawdust.
,r				,
I Excessive	impeller	t.	Picked up large wood
j noise,			chips	or debris.
			Loose	impeller.
		3.	Rubbing impeller.

REMEDY SUGGESTED

1.Tighten connections.

2.a. Sawdust trapped between clamp bag and housing. b. Lower bag is hung up on sawdust shoot extension.

Reposition chip bag properly. See "Maintenance- Chip Bag".

,,,,

1, Do not pick up metalor ferrous materials. Stopthe machine and the material wilt falt to the bottom of inlet tube.

2.Unplug unit prior to disassembly. Hazardous moving parts inside, Attach inlet guard before plugging in. Use a piece of wood 1otree impeller.

3.Consult Sears Service to repair loose or rubbing impeller, A repair to the housing may create a hazard unless it is done by a qualified service technician. Repair service is available at your nearest Sears store.

i _lL L I I

.16