:: 4i Support the opposite side ofFiltration Housingw_th a
b[()ckof wood_
A;:Ptace:O÷Ringin relief of Inlet pipe (See page!8)
5.: Position Inlet Guardin tine with the threaded holesOn
the base of the Filtration Housing.
NOTE: Makesureinlet Guard is pointing to rear of
machine_
6. Place Iockwasher andflat washer on hex screw and
insert through the holes of the Inlet Guard into the
threaded holes of the Filtration Housing as shown.
7. Complete the process for the other three holes using
same method.
DO NOT SECURE SCREWS AT THIS TIME.
MOUNTING SUPPORT LEGS
1. Eocate the following itemsfrom the loose parts bag:
Descrlption -Qty.
AFlat Washers* (5/16 x 11/16 x 3/32) ..... 4
B Hex Screws *(M8 x 1.25 -12) ............... 4
..... C Lockwashers* (5/16) ............................. 4
_CAUTION: To avoid Injury, keep hands away
from fan blade:
3. Place: lockwasher and flat washer on hex screw and
insert: through the holes in the Support Leg and
secure to the threaded holes inthe Filtration Housing
asshown,
4, Use same method to attach Right Support Leg.
AB
"Items are shown actual size
LEG BRACKET I]
C
5. Secure hex screwswiththe use of adjustable wrench.
MOUNTING LEG BRACKET
1. Locate the following items from the loose parts bag:
Description Qty.
A Flat Washers* (5/16x 11/16 x 3/32) ..... 4
B Hex Screws* (MS x 1.25 -12)............... 4
MOTOR /
LEG SUPPOR.r
FLAT WASHER
.\_b,,._/.EX SCREW
_/HEX SCREW
LOCKWASHER
____J_"FLA'r WASHER
IMPELLER
BLOCKS OF WOOD
2i Insert LegBracket between the Support Legs and
slide against:the angied fiange of theLeg.
NOTE: iMake _re :h01es in Leg Bracket align with
.......... L
flangeof Leg Support and attach to threaded holeof
BrackeL
3. Place flat washer on hex Screw, insertthro ugh angled 4: Repeat steps 2and 3 using same process on ,other
three holes.