assembmy
MOUNTING FRONT PRVOTING CASTERS
1, Locate the following items from the loose parts bag:
DescriptionQty.
A | Pivoting Casters | 2 |
B | Hex Nuts* (3/8 - 16) | 2 |
C | Flat Washers* (3/8 x 3/4) | 4 |
D | Acorn Nuts*, | 2 |
E | Base Plate | 1 |
2.Screw a hex nut completely on the Caster bolt.
3.Position flat washeron top of previously installed hex nut and slip the Caster bolt through the hole on front of Base Plate. Position secondflat washeron the bolt.
4.Screw the Acorn Nut on the bolt securely with an adjustable wrench.
5.Tighten the hex nut securely against the base plate.
6, Repeat steps 2 - 5 on opposite side.
i
A
E
0*
*}terns are shown actual size
ACORN NUT_,
FLAT WASHER
CASTER
MOUNTING REAR FIXED CASTERS
1. Locate the following items from the loose parts bag
Descrlptlon |
| Qty. | |
A | Fixed Casters | ....................................... | 2 |
B | Flat Washers* | (1/4 x 1/2) | 4 |
C | Lockwashers* | (1/4) | 4 |
D | Hex Head Screws* (M6 x 1 - 12) | 4 |
2.Position Fixed Casterunder rear of Base Plate so that holes on Caster bracket and Base Plate line up.
3.Install hex screw, lock washer and flat washer as shown, Tighten securely using an adjustable wrench
4.Repeat steps 2 and 3 on opposite side.
i•
MOUNTnNG iNLET GUARD
C_
AB'_
* Items are shown actual size
BASE PLATE
(REAR) _HEX SCREW
FLAT WASHER
F.,_ED CASTER
1. Locate the following items from the loose parts bag:
DescriptionQty
AFlat Washers* (5/16 x 11/16 xl/16) ..... 4
B | Hex Screws* (M8 x 1.25 | 4 |
C | Lockwashers ° (5/16) | 4 |
Ac
2. Locate the Filtration | Housing | and | Inlet Guard. | * Itemsareshown actual size | |
'H,.,HL | L • | .I, , | I | HI, | I ,IHUIL._ |
|
|
|
|
| *V |