Crate Amplifiers GFX2200HT owner manual Rear Panel

GFX2200HT GUITAR AMPLIFIER

The Rear Panel:

EFFECTS LOOP		SPEAKERS
LINE	LINE	160 WATTS @ 4 OHMS
OUT	IN	220 WATTS @ 2 OHMS
		2 OHM MIN. LOAD
22	23	24	25

22.EFFECTS LOOP LINE OUT: When using an external effects processor, con- nect this jack to the input of the effect by means of a shielded signal cable. This jack also doubles as a source for a post-EQ, preamp signal to send your signal to a mix- ing board, recorder, powered monitor or external amplifier.

23.EFFECTS LOOP LINE IN: When using an external effects processor, con- nect this jack to the output of the effect by means of a shielded signal cable. This jack also doubles as a direct connection to the power amp, bypassing the input and pre- amp stages. This is useful for “slaving” a pair of amplifiers together.

24.SPEAKERS: Use these jacks to con- nect the amplifier to your speaker cabi- net(s) using speaker cables with mono 1/4” plugs. These jacks are wired in parallel. Make sure that the combined impedance of your speakers is equal to or greater than 2 ohms! Use the chart below to help deter- mine parallel loads. If in doubt, ask your dealer.

CAB IMP	# CABS TOTAL IMP
4 ohms	2	2 ohms
8 ohms	2	4 ohms
8 ohms	4	2 ohms
16 ohms	2	8 ohms
16 ohms	4	4 ohms
16 ohms	8	2 ohms

25.POWER CORD: This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the rear panel. Don not attempt to defeat the safety ground connection.

5