Crate Amplifiers RFX200S manual Using the Footswitch, RFX200 Rear Panel

RFX200S Three-Channel Guitar Amplifier with Stereo DSP

Using the Footswitch:

The special Crate four-button footswitch supplied with the RFX200S performs a variety of functions. The footswitch allows remote channel selection, remote Tap/Save for each channel, and allows access to an additional DSP preset for each channel of the amplifier. Use only the supplied Crate four-button momentary footswitch with the RFX200S. A standard 5-wire midi cable (supplied) may be used to connect the footswitch to the amplifier.

When the footswitch is connected to the amplifier, the first tap of but- tons 1 - 3 select the corresponding channel. Once a channel is selected, consequent taps of the same button produce the same results as tapping the front panel Save/Tap button – you can use the footswitch to store pre- sets and set the tempo of an effect. (See page 8.)

STEREO	MONO
EFFECTS LOOP	EFFECTS LOOP

FOOT

SWITCH

RETURN SEND RETURN SEND

RFX200 REAR PANEL

The “original” DSP presets are active for each channel when the #4 footswitch LED is illuminated. These are referred to as “DSP Bank ‘A’.” When the #4 button is switched and the LED is off, a second DSP preset may be stored and recalled for each channel - “DSP Bank ‘B’.”

FOOTSWITCH

NOTE: DSP Bank “B” pre-	1
sets are only accessible

when the footswitch is connected to the amplifier. When the footswitch is not connected, only DSP Bank “A” is accessible.

5-Conductor MIDI cable

2 3 4

SWITCH #1:	SWITCH #2:	SWITCH #3:	SWITCH #4:
CH. 1 SELECT;	CH. 2 SELECT;	CH. 3 SELECT;	LED on: DSP BANK A
TAP/SAVE FOR CH. 1	TAP/SAVE FOR CH. 2	TAP/SAVE FOR CH. 3	LED off: DSP BANK B

9