Crate Amplifiers RFX200S manual Bottom Panel

RFX200S Three-Channel Guitar Amplifier with Stereo DSP

The Bottom Panel:

	SPEAKER OUTPUTS			STEREO			MONO
100 WATTS @ 4 OHM MINIMUM LOAD			EFFECTS LOOP			EFFECTS LOOP
RIGHT		LEFT								FOOT
(CHORUS DRY)		(CHORUS WET)	RETURN		SEND	RETURN			SWITCH
								SEND

29 30 31 32 33 34

27:POWER (not shown): Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom) of the switch depressed. The switch illuminates when the power is on.

28:AC LINE CORD (not shown): This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the bot- tom panel. Do not attempt to defeat the safety ground connection.

29:SPEAKER OUTPUTS: Use these jacks to connect the amplifier to the speakers. The RFX200S is shipped from the factory with a cable from each channel connected to the speakers within the cabinet. Additional speakers may be connected providing the four ohm minimum load rating for these jacks is observed. When using the stereo Chorus effect the right channel is dry and the left channel is detuned (wet). Each channel will provide 70 watts RMS into an eight ohm load and 100 watts RMS into a four ohm load.

30:STEREO EFFECTS LOOP RETURN: When using a stereo external effects processor, connect this jack to the output jack of the effect by means of a shielded three conductor signal cable terminated with a stereo (R/T/S) 1/4” connector.

31:STEREO EFFECTS LOOP SEND: When using a stereo external effects processor, connect this jack to the input jack of the effect by means of a shielded three conductor signal cable terminated with a stereo (R/T/S) 1/4” connector.

32:MONO EFFECTS LOOP RETURN: When using a mono external effects processor, connect this jack to the output jack of the effect by means of a shielded signal cable.

33:MONO EFFECTS LOOP SEND: When using a mono external effects processor, connect this jack to the input jack of the effect by means of a shielded signal cable.

34:FOOTSWITCH: Use this jack to connect the footswitch cable (5-conductor midi cable) to the four-button footswitch (supplied). This allows you to remotely switch between the channels, set tap tempos, save new presets, and access a second set of DSP presets. (See page 9 for additional information.)

6