VTX200SH Three-Channel Guitar Amp Head with Stereo DSP

Using the Footswitch:

The special Crate four-button footswitch supplied with the VTX200SH performs a variety of functions. The footswitch allows remote channel selection, remote Tap/Save for each channel, and allows access to an additional DSP preset for each channel of the amplifier. Use only the supplied Crate four-button momentary footswitch with the VTX200SH. A standard 5-wire midi cable (supplied) may be used to connect the footswitch to the amplifier.

When the footswitch is connected to the amplifier, the first tap of but- tons 1 - 3 select the corresponding channel. Once a channel is selected, consequent taps of the same button produce the same results as tapping the front panel Tap/Save button – you can use the footswitch to store pre- sets and set the tempo of an effect. (See page 8.)

The “original” DSP presets are active for each channel when the #4 footswitch LED is illuminated. These are referred to as “DSP Bank ‘A’.” When the #4 button is switched and the LED is off, a second DSP preset may be stored and recalled for each channel - “DSP Bank ‘B’.”

 

FOOTSWITCH

NOTE: DSP Bank “B” pre-

1

sets are only accessible

 

when the footswitch is

 

connected to the amplifier.

 

When the footswitch is not

 

connected, only DSP Bank

 

“A” is accessible.

 

VTX200SH REAR PANEL

5-Conductor MIDI cable

2

3

4

 

 

 

 

 

SWITCH #1:

SWITCH #2:

SWITCH #3:

SWITCH #4:

CH. 1 SELECT;

CH. 2 SELECT;

CH. 3 SELECT;

LED on: DSP BANK A

TAP/SAVE FOR CH. 1

TAP/SAVE FOR CH. 2

TAP/SAVE FOR CH. 3

LED off: DSP BANK B

9

Page 9
Image 9
Crate Amplifiers manual Using the Footswitch, VTX200SH Rear Panel