Creda installation instructions Disposal of your product, Moving the Cooker, J151E / J155E

J151E / J155E

Installation & User Instructions

Jackson is a registered trademark of

General Domestic Appliances LTD.

You must read these instructions prior to using the appliance and retain them for future reference.

For more information on our exciting product range ring

Creda Answer Centre 08701 54 64 74

OR

Visit us on the NET at

http://www.creda.co.uk

Our site invites you to make use of our interactive cookbook and product selector. Feel free to browse our product range to see what’s bubbling away at the moment or to ask for help on our products and services

General Domestic Appliances Ltd. Morley Way Peterborough PE2 9JB

Creda Answer Centre 08701 54 64 74 Web http://www.creda.co.uk

It may be necessary from time to time to change the specification outlined in this booklet without notice. Any change which is made will not affect your statutory rights.

Your new appliance is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet.

To help make best use of your cooking equipment, please read this booklet carefully.

The cooker is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.

When the cooker is first used an odour may be emitted, this will cease after a period of use.

When first using the cooker ensure that the room is well ventilated (e.g. open a window or use an extractor fan) and that persons who may be sensitive to the odour avoid any fumes. It is suggested that any pets be removed from the room until the smell has ceased. This odour is due to temporary finish on oven liners and elements and also any moisture absorbed by the insulation.

*The guarantee is subject to the provisions that the appliance:

(a)Has been used solely in accordance with the Users Instruction Book.

(b)Has been properly connected to a suitable supply voltage as stated on the rating plate attached to this equipment.

(c)Has not been subjected to misuse or accident or been modified or repaired by any person other than the authorised employee or agent.

(d)Has been correctly installed.

Installation	WARNING – THIS APPLIANCE MUST BE EARTHED.
	Your cooker should have been checked to ensure
	that the voltage corresponds with your supply
	voltage, this is stated on the rating plate, which is
	situated on the rear panel. The cooker must be
	connected by a competent person eg, NICEIC
	registered contractor to suitable double-pole
	control unit with a minimum rating of 45A and a
	minimum contact clearance of 3mm, which
	should be fitted adjacent to the cooker, in
	accordance with IEE regulations.
	The power supply cable should conform to
	B.S.6004 with a conductor size of 6mm2
	minimum.
	The control unit should be easily accessible in the
	event of an emergency, but must be within 2
	metres of and not directly above an appliance.
	This appliance conforms to EN 55014 regarding
	suppression of radio and television interference.
	Access to the mains terminals is gained by
	removing the rear access cover.
	The mains cable must pass through the cable
	clamp adjacent to the terminal block. Sufficient
	cable should be used to allow the cooker to be
	pulled out for servicing.
	Ensure that the mains cable is routed away from
	any brackets affixed to the rear panel and is not
	trapped to the rear wall when pushing the cooker
	into position between cabinets.
	The height of the cooker can be adjusted by
	means of adjustable feet in the plinth (900mm -
	915mm). Adjust the feet by tilting the cooker
	from the side. Then install the product into
	position.

Siting the Cooker The cooker is designed to fit between kitchen cabinets spaced 500mm apart. The space either side need only be sufficient to allow withdrawal of the cooker for servicing. It can be used with cabinets one side or both as well as in an angled corner setting. It can also be used free-standing.

This cooker is a type X appliance, as such adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer than 650mm.

Never mount the cooker onto a platform.

Disposal of your product

To minimise the risk of injury to children please dispose of your product carefully and safely. Remove all doors and lids. Remove the mains cable (where fitted) by cutting off flush with the appliance and always ensure that no plug is left in a condition where it could be connected to the electricity supply.

To help the environment, Local Authority instructions should be followed for the disposal of you product.

Moving the Cooker

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.

Movement of your cooker is most easily achieved by lifting the front as follows:

Open the oven/grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements or oven interior furniture.

Note: Take care in moving the cooker as it is heavy.

Take care to ensure that any floor covering is not damaged.

Splash panel kit (wall mounted) optional, apply to Creda Parts Department.