How To Operate Your Dryer
WATER
CONTAINER
PLINTH MOULDING WHEN FITTED
EMPTY WATER
CONTAINER
LIGHTWATER
CONTAINER
SINK
13.Remove plinth moulding (where fitted) by slightly lifting and sliding to the left. Remove the
water container and empty after EVERY programme. Failure to do this will result in the water container becoming full and the load will not dry.
NOTE: The light on the control panel only comes on when the water container is full. When the light is on you should stop the dryer and empty the water container. This should be avoided by emptying the container between cycles. If the light comes on during a cycle (Eco machines) the timer will automatically advance to ‘cool run’.
14.EVERY month, remove and clean the Condenser unit by pouring cold water through all the tubes. This prevents the air passage ways from
| being blocked by fluff. |
FLUFF | |
FILTER |
|
|
|
TAP
REAR
FRONT
CONDENSER
12
