CD43 mk2 Compact Disc Player
SAFETY W ARNINGS
CAUTION!
Invisible laser radiation
when top cover is
removed.
CAUTION
PERFORMING ADJUSTMENTS OR PROCEDURES OTHER THAN THOSE SPECIFIED HERE MAY RESULT IN HAZARDOUS EXPOSURE.
THE CD PLAYER SHOULD NOT BE REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL.
Class 1 Laser Product 
SPECIFICATION
Power requirements | AC |
Power Fuse rating | T 250 mA |
or: | AC |
| T 500 mA |
Power consumption | 16 Watts max |
Frequency response | 1 Hz - 20 kHz ± 0.5 dB |
Output level | 2.2 V RMS at 1kHz, 0 dB |
Output impedance | 600 Ω , min load 10 kΩ |
Laser type | Semiconductor ALGaAs |
Wavelength | 790 nm ± 25 nm |
Light output (cw) | 0.18 mW typical |
Signal to noise ratio | better than 96 dB |
Dynamic range | better than 100 dB |
Number of channels | 2 |
Total harmonic distortion | < 0.01% at 1 kHz, 0 dB |
Dimensions | 420 x 60 x 200 mm |
OTHER FEATURES
1.
2.High precision 24 bit, ∆Σ digital to analogue conversion.
3.128 Fs filter.
4.
5.16 program memory.
6.LCD display - back lit green.
7.Shuffle function (random selection).
8.Repeat facility.
9.Intro scan facility.
Note: The specification and design are subject to change for improvements without notice.
N O T E
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause interference to radio communications. However, there is no guarantee that interference will not occur in some instances. If this product causes interference to radio or television reception, which can be determined by turning the equipment off and on, try to correct this by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the radio or TV receiver.
Connect the equipment into a mains outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.
3
