CD43 mk2 Compact Disc Player
REMOVING THE DISC
The disc tray can be opened at any time by pressing the O P E N / C L O S E button. Remove the disc only after the tray has fully opened.
CAUTION
uDo not put anything except a Compact Disc into the tray. Foreign objects can damage the mechanism. DVD’s will not play.
uDo not force the tray by hand during the opening and closing operations.
uTo avoid dirt and dust entering the mechanism, keep the disc tray closed when the CD player is not in use.
uNever load two discs into the disc tray.
C O N T R O L A N D O P E R ATION
This section describes the CD player's controls in the order in which you would normally use them. Follow the instructions
P O W E R
The CD43 mk2 is equipped with a mains On/Off switch on the rear panel next to the power cord. The marking on the panel clearly shows that 1 is on and 0 is off.
Switching on the power from the rear panel automatically places the CD43 mk2 in Standby mode. To wake it up, press the STANDBY button on the front panel or STBY on the remote handset. The LED indicator will alternate from yellow colour in Standby mode to green when ready to play. The display will also illuminate when ready to play. If the drawer is open, it will close automatically when Standby is pressed.
To wake up the CD43 mk2, press any button. However, the disc drawer can be opened immediately from Standby.
N O R M A L DISC PLAY
Before playing a disc, check the player's power cable and output cable connections.
1.Switch on the CD43 mk2 at the rear panel, a yellow LED will light above the power button.
2.Press the STANDBY switch on. The LED will turn green.
3.Press the OPEN/CLOSE or DISC button to open the disc tray and load the disc.
4.Press the OPEN/CLOSE or DISC button
again to close the disc tray.
N.B. If you get a message dISC on the display when the disc tray is fully closed, this means that the disc is improperly loaded (most likely upside down). To check, open the disc tray again and reload the disc correctly.
If the disc tray gets jammed while closing, the tray will stop and open automatically. If this happens check the disc tray and reload the disc correctly.
5.When the disc is loaded correctly the the player will spin the disc to read the TOC (table of contents). This will tell the player how many tracks are recorded on the disc and how long they are. Depending on the number of tracks and the method of recording the information, the TOC read can vary from 3 - 10 seconds or more. Until this has been achieved, no other function will work. When the TOC is correctly read the player will display the information.
For example:
There are 8 tracks on the disc. The total playing time is 48 minutes and 54 seconds. The player is set to play when required.
6.Press the PLAY button. The PLAY symbol will appear on the display. The disc will start
8
