Cres Cor 1000-CH-AL-SPLIT INSTALLATION INSTRUCTIONS continued, How To Install Cabinets, FL-2340

Ovens	FL-2340
Rev. 5 (7/08)	Page 4 of 14

5925 Heisley Road • Mentor, OH 44060-1833

INSTALLATION INSTRUCTIONS (continued)

HOW TO INSTALL CABINETS:

1.Remove all packing material from the inside and all vinyl from the outside of oven.

2.Place the oven in a well ventilated area on level floor. Clearance requirements: 3” (76mm) at the back, 2” (51mm) at the top, 1” (25mm) at both sides.

3.Install the pan slide racks on the sidewalls, if necessary.

4.Slide drip pan(s) onto the bottom of the compartment(s).

5.Remove (3) screws at the bottom front of the oven, under the door (See Figure).

6.Screw the drip tray bracket to the oven in those holes and place the drip tray onto the bracket.

All models are rated at 208/240 Volts.

NOTE: OVENS NEED TO BE INSTALLED BY A QUALIFIED PERSON.

Check the voltage selector switch which is under an access cover on the back of the oven near the power cord.

Flip the switch “UP” for 208 Volts Flip the switch “DOWN” for 240 Volts

MAKE SURE THE SWITCH POSITION MATCHES YOUR POWER SOURCE.

DRIP TRAY

DRIP TRAY

BRACKET

SCREWS

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com