Crimestopper Security Products CS-2004 WDC Alarm Cycle Reset, REMOTE AUX. OUTPUT 1 OPTIONAL

OPERATION

ALARM CYCLE RESET

If and when the alarm system is triggered, pressing the #2 button on either transmitter will reset the unit’s cycle (lights, siren) condition without disarming it. Pressing the button a #2 button second time will Disarm/Unlock the system.

REMOTE AUX. OUTPUT 1 (OPTIONAL,)

Note: AUX 1cannot be operated with the SecurWatch transmitter if the alarm system is programmed for Carjack protection. To activate an optional feature such as a trunk/hatch pop (if vehicle is properly equipped), press Button #3 (AUX) on the 4-Button CoolGlow remote or press and hold Button #2 (when disarmed) on the SecurWatch® transmitter. This provides a ½ second auxiliary pulse to activate a relay for power trunk release or other optional feature. (Extra parts and/or labor may be required for this feature.)

REMOTE PANIC PROTECTION

To sound the alarm upon command (panic), press and hold the Button #1 on either transmitter for at least 3 seconds until the siren sounds and lights flash. Press Button #2 to reset the panic mode.

ARMING WITHOUT SHOCK SENSOR

To arm the alarm without Shock sensor protection, press Button #1 as normal then press and hold Button #4 (SLNT) for about 3 seconds until the unit flashes the lights 3 times indicating shock sensor bypass. (Button #1, then 1+2 w/Watch)

SHOCK / IMPACT PROTECTION WITH PRE-WARNING

Once the system is armed, if a low-level shock to the vehicle body is detected, the pre-warning sensor activates with 5 siren chirps and one light flash as a Warn-Away feature. If a hard impact to the vehicle is detected the system will go into a full trigger cycle for 20 seconds. Adjust the shock sensor as needed by turning the control knob clockwise or counter-clockwise to increase or decrease the sensitivity. Shock sensors will “settle in” over time and it may take a few tries over a few weeks to get the adjustment correct for your vehicle. We recommend a moderate adjustment where the vehicle is protected but it is not constantly triggering from the slightest vibration therefore creating a nuisance.

EMERGENCY OVERRIDE/DISARM

If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to open the door with the key, (activating the alarm), turn the ignition ON, press and hold the override/program until the system disarms (about 7 seconds). The Alarm will disarm allowing you to operate the vehicle until you can repair/replace the remote transmitter.

VALET MODE

To put the Alarm system into valet mode for vehicle service or otherwise, turn the ignition on and press the Button #4 (SLNT) on the remote until lights flash 3 times. The in-dash LED turns on solid. Repeat the procedure to exit VALET mode. The system will chirp 3 times and the LED will turn off on Valet mode exit. Lock/Unlock and AUX features will still operate in when in VALET mode. (IGN ON, then Buttons 1+2 w/Watch)