Crimestopper Security Products CS-2004 WDC Silent Arm/Disarm, Passive Arming / Passive Lock Modes

OPERATION

SILENT ARM/DISARM

Use Button #4 (SLNT) for silent arm and disarm (Chirp Defeat). Press and release Button #4 to arm/disarm without the siren chirp. The light flash will be your only confirmation on Arm/Disarm. (Buttons 1+2 w/Watch)

PASSIVE ARMING / PASSIVE LOCK MODES

If programmed, passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last door has been closed. The lights will flash twice when the last door is closed and the LED will begin flashing rapidly while counting down. If a door is reopened the countdown will reset and, the system will wait for the door or zone to close before starting 30 second countdown again. The unit will chirp once and flash the lights once. Doors will lock if passive locking is selected. May qualify for insurance discounts-check with your agent or proprietor. See Jumper Plug programming for J1 Passive Arm and J2 Passive Lock settings.

PRIOR INTRUSION ALERT

If the system was tripped in your absence, the dash LED will be flashing rapidly. When the system is disarmed you will hear 2 chirps, a pause then 4 chirps. Carefully inspect your vehicle to see if there is any damage or a theft has occurred.

DOME LIGHT ILLUMINATION (OPTIONAL)

This feature turns on the vehicles dome light upon disarm for 30 seconds or until the key is inserted and turned on. This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security. (Extra parts and/or labor may be required for this feature.)

DOOR OPEN WARNING

If the system detects a faulty or open zone (Door left open) when the system is armed with a remote, it will trigger 5 within 5 seconds. If your vehicle is equipped with a dome light that stays on after exiting, this will affect the operation of the unit. If your vehicle is so equipped, then the Jumper Pin J3 should be removed (open) to allow the alarm system to compensate for a delayed dome light. See Jumper Plug programming.

AUTOLOCK/UNLOCK

Autolock / Unlock allows the alarm to control the door locks automatically with the vehicle’s Ignition. When the ignition is turned on, 6 seconds later, the doors will lock. When the ignition is turned off, the doors will unlock. Doorlock with Ignition ON will not occur if a door is open to prevent accidentally locking the keys in the vehicle.

2nd AUX. OUTPUT (REMOTE AUX. OUTPUT 2)

To activate the Second auxiliary output, press and hold Button #4 (SLNT) for more than 2 seconds. If the system is armed, you will need to press and hold Button #4 a second time to activate the feature. (The first time activates sensor bypass only) This output can be used to control other optional add-on accessories such as Remote Engine Start Modules, Window Roll up/down modules, etc. This output is momentary and will stay active as long as the button on the remote is held down.