Crimestopper Security Products CS-2004 WDC operating instructions Starter Disable Wiring

STARTER DISABLE WIRING

STARTER DISABLE PLUG: 3 ORANGE 14 GA. WIRES:

(Normally Closed or Normally Open Configuration with ON-Board Relay)

Note: read the following configuration options before connecting starter disable!

Normally Closed Starter disable is the standard type used with most alarm systems today. This circuit will disable the Starter while the alarm is armed or has been triggered. If 12V power is removed from the system, the Battery goes dead, or the alarm is removed for service the vehicle will start normally as if no alarm were installed. (Factory Default)

Normally Open Starter Disable is a High-Security circuit that will disable the starter while the alarm is armed or triggered AND if the unit is unplugged or removed from power. This means that if the vehicle’s Battery goes dead or the unit is unplugged from the vehicle, the car will still not start. We only recommend this type of circuit if you can install a hidden high-current toggle switch to defeat the Normally Open disable in case of a dead battery or if the unit is unplugged/remove for service. (Toggle not included)

IGN

SWITCH

ORANGE

ORANGE

ORANGE

NORMALLY CLOSED STARTER DISABLE (DEFAULT)

START WIRE

CUT

N/C

COM

N/O

NOTE ALIGNMENT OF PLUG

N/C = NORMALLY CLOSED

STARTER

IGN

SWITCH

ORANGE

ORANGE

ORANGE

**JUMPER #7 MUST BE REMOVED!**

NORMALLY OPEN STARTER DISABLE (OPTIONAL)

START WIRE	CUT
	STARTER
N/C
COM
N/O
NOTE ALIGNMENT OF PLUG	HIDDEN TOGGLE
N/O = NORMALLY OPEN	SWITCH
	(NOT INCLUDED)