Crown CTS 8200 Setup, CTs Multi-Channel Power Amplifiers, page, See the Crown Amplifier Appli

CTs Multi-Channel Power Amplifiers

3 Setup

See the Crown Amplifier Appli-

3.6 Wire Your System

CAUTION: Never change the position of the Mode Switch while the amplifier power is on. See Section 5.2.2 for more information.

3.6.1 Dual 8/4 Mode

Typical input and output wiring, along with level control and Mode Switch settings are shown in Figure 3.6. Make sure the Mode switch is set to the “Dual 8/4” position.

INPUTS: Connect input wiring for each channel.

OUTPUTS: Maintain proper polarity (+/–) on output connectors.

Connect the Channel 1 speaker’s positive (+) lead to amplifier Channel 1 positive terminal; repeat for negative (–). Repeat each channel wir- ing as for Channel 1. Refer to Section 3.5 for output connector pin assignments.

BRIDGE
DUAL	DUAL
CH 2	CH 1

CH 4 CH 3

DUALDUAL

BRIDGE

Figure 3.6 System Wiring and Control Settings, Dual Mode, 8/4 Ohm

cation Guide, available online at www.crownaudio.com, for pin assignments for commonly used connector types.

Output panel

shown with touch-proof cover plate removed.

3.6.2 Dual 70V Mode

CAUTION: Never change the position of the Mode Switch while the amplifier power is on. See Section 5.2.2 for more information.

Typical input and output wiring, along with level control and Mode Switch settings are shown in Figure 3.7. Make sure the Mode switch is set to the “Dual 70V” position.

INPUTS: Connect input wiring for each channel.

OUTPUTS: Maintain proper polarity (+/–) on output connectors.

Connect Channel 1 positive (+) speaker load to Channel 1 positive terminal of amp; repeat for negative (–). Repeat each channel wiring as for Channel 1. Refer to Section 3.5 for output con- nector pin assignments.

70V
	BRIDGE
	DUAL	DUAL
70V	CH 2	CH 1

CH 4	CH 3
DUAL	DUAL
BRIDGE

Output panel

shown with touch-proof cover plate removed.

Figure 3.7 System Wiring and Control Settings, Dual Mode, 70V.

page 8 Operation Manual