Commercial Audio Series
2 Setup
2.3 Choose Input Wire and Connectors
Crown recommends using
Figure 2.3 shows connector pin assignments for balanced wir- | |
ing, and Figure 2.4 shows connector pin assignments for unbal- |
|
anced wiring. The RCA input connectors can also be used for |
|
| |
unbalanced inputs. |
|
Figure 2.3 Balanced Input Connector Wiring
2.4 Choose Output Wire and Connectors
For the amplifier output connectors, Crown recommends using
Figure 2.4 Unbalanced Input
Connector Wiring
BALANCED LINE
nections with the supplied
Using the guidelines below, select the appropriate size of wire based on the distance from amplifier to speaker. The wire sizes apply to the
Distance | Wire Size | |
up to 25 ft. | 16 AWG | |
14 | AWG | |
12 | AWG | |
10 | AWG | |
8 | AWG | |
6 | AWG |
NOTE: Custom wiring should only be performed by qualified personnel. Class 2 wiring is required.
CAUTION: Never use shielded cable for output power wiring.
Use
Figure 2.5 Two Amplifier Output Connectors on 280MA Back Panel
(One Connector in 180MA and 1160MA)
S | SHIELD | TO DESTINATION |
| ||
|
|
| UNBALANCED LINE | TO DESTINATION | |
|
| ||
| SHIELD | UNGROUNDED | |
S | PRODUCT WITH | ||
| |||
|
| ||
OUTPUT | (This connection reduces | CORD ONLY | |
| |||
| the signal level by 6 dB.) |
|
Figure 2.6 Line Out Wiring.
Top: Balanced. Bottom: Unbalanced.
Operation Manual | page 9 |