Crown Audio CE2000TX operation manual Bridge-Mono Mode, Typical System Wiring, Bridge Mono Mode

3Setup

3.6.2Bridge-Mono Mode

Make sure the amplifier is turned off and the level controls are turned down before you wire the system.

Typical input and output wiring is shown in Figure 3.11.

INPUTS: Connect input wiring to lower-num- bered channel pair.

OUTPUTS: Connect the speaker across the posi- tive terminals of each channel pair. Do not use the negative terminals of the channel pair when the pair is being operated in Bridge-Mono mode. Refer to Section 3.5 for output connector pin assignments. Make sure the Mode switch is set to the “Bridge” position when operating in Bridge-Mono mode.

NOTE: Turn down (full CCW) the Channel 2 level control when operating the channel pair in Bridge-Mono mode, as the Channel 1 level control works both channels.

NOTE: Crown provides a reference of wiring pin assignments for commonly used connector types in the Crown Amplifier Application Guide available at www.crownaudio.com.

CE2000TX Power Amplifier

SHOWN WITH OPTIONAL CEAS1 OUTPUT MODULE

Figure 3.11 Typical System Wiring, Bridge Mono Mode

page 10 Operation Manual