Installation Instructions
759-04080 CRUISE CONTROL KIT
For Series 6000 Tractor Models
KIT COMPONENTS
3
1 2
Ref. |
| Pt. No. |
| Description |
|
1. | 1750736 |
| Special Screw | ||
2. | 1768971 |
| Magnet w/Spring Assy. | ||
3. | Cruise Latch Bracket | ||||
4. | Hex Jam Nut, | ||||
5. | Cable Tie | ||||
6. | Cruise Switch |
7.
5
6
7
4
Introduction
The cruise control kit is designed to allow the tractor op- erator to maintain a desired “foot free” forward speed in areas where constant speed changes are not re- quired. The cruise control feature can only be operated in the forward direction.
Installing the Cruise Control Kit
NOTE: Some installation procedures are more easily performed from beneath the tractor. If equipped, the mower deck may be removed from the tractor to im- prove access.
Wire leads w/connectors needed to power the cruise control magnet are provided in the tractor wire harness.
To install the cruise control kit, proceed as follows:
•Remove the plug from the right side of the dash panel by sliding a thin flat edged tool beneath the plug and prying upward. See Figure 1.
NOTE: The wire harness connector for the cruise switch may be connected to the dash panel plug. If so, carefully pull the wire harness connector up through the dash panel while removing the plug. If the wire harness leads are not connected to the plug, it will be necessary to re- move the dash panel insert.
Remove
Plug
Figure 1
CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
PRINTED IN U.S.A. | FORM NO. |
1