Cub Cadet 930 SWE Always stop engine, Disconnect spark, Plug, and ground Against engine before

6			6.	Slip the auger control belt (the front belt) off the
		Remove		engine pulley.
			7.	Pull the brake bracket assembly towards the cable
				guide roller and unhook the auger cable “Z” fitting.
				See Figure 6-9.
Maintaining			8.	Remove the upper bolts which attach the auger housing
				Refer to Figure 6-4 on previous page.
Your Snow				assembly to the frame assembly using a 9/16” wrench.
	Loosen		9.	Place a block of wood underneath the auger housing as

Thrower	shown in Figure 6-10 and separate auger housing from
	the frame by tilting the housing forward and pulling up
	the handles.

10. a. Using a 1/2” wrench, remove the hex screw and cupped washer from the center of the pulley on the auger housing. See Figure 6-11.

b. Lift the brake bracket assembly out of the pulley

groove

Figure 6-6c. Remove the pulley. Be careful not to lose the key. 11. Remove and replace auger belt inside belt keepers.

12. Apply Loctite 262 to the threads of the hex screw used

WARNING	for mounting the auger pulley.
	13. Reassemble pulley to auger housing with hex screw
Always stop engine,	and cupped washer (cupped side toward the pulley).
	Torque hex screw 150-250 in. lbs.
disconnect spark
plug, and ground	NOTE: Make sure key is in place on shaft and brake puck
against engine before	is seated in the pulley groove.
performing any type
of maintenance on
your machine.

Figure 6-7

Figure 6-8

18