Cub Cadet 933 SWE, 930 SWE warranty Shear Pin Storage

3.a. Remove the flat washer and hairpin clip from the end of the chute directional control. See Figure 3-3.

b.Insert the end of the chute directional control into the chute bracket and secure with the flat washer and hairpin clip just removed. If necessary, the chute bracket can be adjusted. Refer to the Adjustments section.

IMPORTANT: Prior to operating your snow thrower, refer to Auger Control Test in the Operation section. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

4.Remove lock nuts and screws securing one of the flange keepers to the chute assembly.

5.Place chute assembly onto chute base as shown in Figure 3-4, making sure that the notches engage with the spiral end of chute directional control.

6.Secure flange keeper removed earlier with lock nuts and screws. Tighten down nuts securing the other two flange keepers. See Figure 3-5.

7.Check that all cables are properly routed through the cable guide on top of engine shroud. See Figure 3-6.

The extension cord is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove it before operating the snow thrower.

Shear Pin Storage

Holes are located in the plastic dash panel for convenient shear pin storage. See Figure 3-7.

Figure 3-7

Figure 3-4

Figure 3-5

Figure 3-6

3

Setting Up

Your Snow

Thrower

IMPORTANT

Prior to operating your snow thrower, refer to Auger Control Test in the Operation section. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

Specifications are subject to change without notification or obligation. Images may not reflect your exact model and are for reference purposes only.