Troubleshooting | 8 |
| |
|
|
| Problem |
| Cause |
| Remedy |
|
|
|
|
|
|
|
|
|
|
Engine fails to start | 1. | Spark plug wire disconnected. | 1. | Connect wire to spark plug. |
| 2. | Fuel tank empty or stale fuel. | 2. | Fill tank with clean, fresh gasoline. |
| 3. | Choke not in CHOKE position. | 3. | Move choke to CHOKE position. |
| 4. | Faulty spark plug. | 4. | Clean, adjust gap, or replace. |
| 5. | Blocked fuel line. | 5. | Clean fuel line. |
| 6. | Throttle control lever not in correct starting | 6. | Move throttle lever to FAST position. |
|
| position. |
|
|
|
|
|
|
|
Engine runs erratic | 1. | Log Splitter running with CHOKE applied. | 1. | Move choke lever to OFF position. |
| 2. | Spark plug wire loose. | 2. | Connect and tighten spark plug wire. |
| 3. | Blocked fuel line or stale fuel. | 3. | Clean fuel line; fill tank with clean, fresh |
|
|
|
| gasoline. |
| 4. | Water or dirt in fuel system. | 4. | Drain fuel tank. Refill with fresh fuel. |
| 5. | Dirty air cleaner. | 5. | Clean or replace air cleaner. |
| 6. | Carburetor not adjusted properly. | 6. | See authorized service dealer. |
|
|
|
|
|
Engine Overheats | 1. | Engine oil level low. | 1. | Fill crankcase with proper oil. |
| 2. | Dirty air cleaner. | 2. | Clean or replace air cleaner. |
| 3. | Carburetor not adjusted properly. | 3. | See authorized service dealer. |
|
|
|
|
|
Cylinder rod will not move | 1. | Broken drive shaft. | 1. | See authorized service dealer. |
| 2. | Shipping plugs left in hydraulic hoses. | 2. | Disconnect hydraulic hoses, remove shipping |
|
|
|
| plugs, reconnect hoses. |
| 3. | Set screws in coupling not adjusted properly. | 3. | See Service Section for correct adjustment. |
| 4. | Loose shaft coupling. | 4. | Correct engine/pump alignment as |
|
|
|
| necessary. |
| 5. | Gear sections damaged. | 5. | See authorized service dealer. |
| 6. | Damaged relief valve. | 6. | See authorized service dealer. |
| 7. | Hydraulic lines blocked. | 7. | Flush and clean hydraulic system. |
| 8. | Incorrect oil level. | 8. | Check oil level. |
| 9. | Damaged directional valve. | 9. | See authorized service dealer. |
| 10. Blocked directional valve. | 10. Flush and clean hydraulic system | ||
|
|
|
|
|
17