Cuisinart WCH-950 manual Unpacking & Placement, Preparing the Water Filter, Water Filter Setup

UNPACKING & PLACEMENT

1.Remove your Cuisinart® Countertop Filtration System carefully from the box.

2.Position the unit on a stable flat surface, close to a main power outlet. Avoid direct sunlight and keep out of the reach of children.

3.Allow at least 3 inches of space around the sides and rear of the unit for proper air circulation.

4.Remove filter from upper tank and carefully follow the SETUP instructions below.

NOTE: Do not plug in unit until ALL steps of SETUP are complete.

WATER FILTER SETUP

NOTE: For optimum filtering and flow rates, the water filter must be prepared and installed exactly as follows:

Preparing the Water Filter

1.Remove the filter from its packaging. It may appear moist, which is normal.

DO NOT wash filter with soap and water.

2. Place water filter in empty bowl sideways (see image). Pressing it

firmly to the bottom of the bowl, and being careful

not to pour water directly onto the filter, slowly add enough cold water to fully submerge and cover the

filter by at least 1 inch. (You should see bubbles escaping the filter.)

3.Continue to hold filter under water for at least 30 seconds.

4.Release the filter and let it soak at least 15 minutes. NOTE: While

soaking, the filter should be partially submerged and may tilt to one side.

Installing the Prepared

Water Filter

1.While the filter is soaking, remove the lid, upper water tank and lower water tank.

2.Remove the filter timer from the lid by flipping the lid over and pressing on the plastic tab.

3.Wash both tanks and plastic lid in mild, soapy water, and rinse. Replace the filter timer.

4.Lift the filter from the bowl and allow water to drain.

NOTE: The filter may contain a small amount of loose carbon dust which can slightly darken water while soaking.

5. With the Cuisinart logo facing up, insert the water filter into the upper water tank and push firmly into place.

6.Place the upper tank on a pitcher and fill with cold tap water. Allow to drain for 5 minutes to flush out any remaining carbon dust, then pour out remaining water.

WATER DISPENSER SETUP

NOTE: Use only cold tap water to fill the unit.

Filling the Upper and Lower Tanks

1. Place the upper tank onto the lower tank and put on the lid.

Lid

Upper water tank

Lower water tank

2.Place assembled tanks on base. NOTE: The vertical groove on the upper tank must face the back of the unit.

3.Carefully lift the flip top lid and add water to the FILL line. NOTE: This is a gravity fill system. To increase the filtering-flow rate, continue adding water to the FILL line of the upper tank until lower tank is completely full.

4.During the initial setup, allow 30-40 minutes for water to filter into and completely fill lower tank.

4