Option | Description |
|
|
Port B | Auto enables BIOS support for the device attached to |
(Off default) | SATA port B. Off disables BIOS support for the device. |
|
|
Port C | Auto enables BIOS support for the device attached to |
(Off default) | SATA port C. Off disables BIOS support for the device. |
|
|
Port D | Auto enables BIOS support for the device attached to |
(Off default) | SATA port D. Off disables BIOS support for the device. |
|
|
Port E | Auto enables BIOS support for the device attached to |
(Auto default) | SATA port E. Off disables BIOS support for the device. |
|
|
Boot Settings Screen |
|
|
|
Option | Description |
|
|
Boot Mode | CAUTION: Switching the boot mode could prevent |
(BIOS default) | the system from booting if the operating system was |
| not installed in the same boot mode. |
| If the system operating system supports Unified |
| Extensible Firmware Interface, you can set this option |
| to UEFI. Setting this field to BIOS allows compatibility |
| with |
| NOTE: Setting this field to UEFI disables the Boot |
| Sequence, |
| Drive Emulation Type fields. |
|
|
Boot Sequence | If Boot Mode is set to BIOS, this field provides the |
| location of the operating system files for startup. If Boot |
| Mode is set to UEFI, you can access the UEFI boot |
| manager utility by rebooting the system and pressing |
| <F11> when prompted to do so. |
|
|
The sequence of hard drives. Use the up and down arrow | |
| keys to choose the hard disk. |
|
|
USB Flash Drive | Determines the emulation type for a USB flash drive. |
Emulation Type | Auto automatically chooses the appropriate emulation |
| |
| type for the device. |
|
|
Boot Sequence Retry | If this field is Enabled and the system fails to boot, |
(Disabled default) | the system reattempts to boot after 30 seconds. |
|
|
Using the System Setup Program and UEFI Boot Manager
57
