
Table 1-2. System Messages (continued)
Message | Causes | Corrective Actions |
General failure The operating system is unable to carry out the command.
This message is usually followed by specific information. Note the information, and take the appropriate action to resolve the problem.
Invalid | An invalid system | Run the System Setup |
configuration | configuration caused a | program and review the |
information - | system halt. | current settings. See "Using |
please run SETUP |
| the System Setup Program |
program. |
| and UEFI Boot Manager" on |
|
| page 51. |
|
|
|
Keyboard | Faulty keyboard controller; | See "Getting Help" on |
controller | faulty system board | page 157. |
failure |
|
|
Keyboard data | Keyboard cable connector is | Reseat the keyboard cable. |
line failure | improperly connected or the | If the problem persists, |
Keyboard stuck | keyboard is defective. | see "Troubleshooting a USB |
| Device" on page 130. | |
key failure |
| |
|
| |
Keyboard fuse has | Overcurrent detected at the | See "Getting Help" on |
failed | keyboard connector. | page 157. |
Local keyboard | The USB ports are disabled | Power down and restart the |
may not work | in the system BIOS. | system from the power |
because all user |
| button, and then enter the |
accessible USB |
| System Setup program to |
ports are |
| enable the USB port(s). |
disabled. If |
| See "Entering the System |
operating |
| Setup Program" on page 52. |
locally, power |
|
|
cycle the system |
|
|
and enter system |
|
|
setup program to |
|
|
change settings. |
|
|
Manufacturing | System is in | Reboot to take the system |
mode detected | manufacturing mode. | out of manufacturing mode. |
40
About Your System