Table 1-2. System Messages (continued)
Message | Causes | Corrective Actions |
Unable to launch | System halted after |
System Services | F10 keystroke because |
image. System | System Services image |
halted! | is either corrupted in the |
| system firmware or has |
| been lost due to system |
| board replacement. |
Restart the system and update the Unified Server Configurator repository to the latest software to restore full functionality. See the Unified Server Configurator user documentation for more information.
Unexpected | Improperly seated | Reseat the memory modules. |
interrupt in | memory modules or | See "Troubleshooting System |
protected mode | faulty keyboard/mouse | Memory" on page 137. If the |
| controller chip. | problem persists, see |
|
| "Getting Help" on page 157. |
|
|
|
Unsupported CPU | Processor is not supported | Install a supported processor. |
combination | by the system. | See "Processor" on page 112. |
Unsupported CPU |
|
|
stepping |
|
|
detected |
|
|
Unsupported | Invalid memory | Ensure that the memory |
DIMM detected. | configuration. The system | modules are installed in a |
The following | will run but with the | valid configuration. See |
DIMM has been | specified memory | "General Memory Module |
disabled: x | module disabled. | Installation Guidelines" on |
|
| page 98. |
|
|
|
Unsupported | Invalid memory | Ensure that the memory |
memory | configuration. Memory | modules are installed in a |
configuration. | modules are mismatched | valid configuration. See |
DIMM mismatch | in the specified slots. | "General Memory Module |
across slots |
| Installation Guidelines" on |
detected: |
| page 98. |
x,x,... |
|
|
48
About Your System