Table 1-2. System Messages (continued)
Message | Causes | Corrective Actions |
Caution!
NVRAM_CLR jumper is installed on system board
NVRAM_CLR jumper is installed in the clear setting. CMOS has been cleared.
Move the NVRAM_CLR jumper to the default position (pins 3 and 5). See Figure
the BIOS settings. See "Using the System Setup Program and UEFI Boot Manager" on page 51.
CPU set to | The processor speed may be | If not an intentional setting, |
minimum | intentionally set lower for | check any other system |
frequency. | power conservation. | messages for possible causes. |
CPU x installed | Memory modules are | Install memory modules for |
with no memory. | required but not installed in | the processor. See |
| the indicated processor’s | "Expansion Cards" on |
| memory slots. | page 103. |
|
|
|
Current boot mode | The system failed to boot | Ensure that the boot mode |
is set to UEFI. | because UEFI boot mode | is set correctly and that |
Please ensure | is enabled in BIOS and | the proper bootable media |
compatible | the boot operating system | is available. See "Using the |
bootable media is | is | System Setup Program and |
available. Use |
| UEFI Boot Manager" on |
the system setup |
| page 51. |
program to change |
|
|
the boot mode as |
|
|
needed. |
|
|
Decreasing | Faulty or improperly | Reseat the memory modules. |
available memory | installed memory modules. | See "Troubleshooting System |
|
| Memory" on page 137. |
38
About Your System
