Table 1-2. System Messages (continued)
Message | Causes | Corrective Actions |
No boot sector on Incorrect configuration
hard drive settings in System Setup program, or no operating system on hard drive.
Check the
See "Using the System Setup Program and UEFI Boot Manager" on page 51.
If necessary, install the operating system on your hard drive. See your operating system documentation.
No timer tick | Faulty system board. | See "Getting Help" on |
interrupt |
| page 157. |
PCI BIOS failed | PCIe device BIOS (Option | Reseat the expansion card(s). |
to install | ROM) checksum failure | Ensure that all appropriate |
| detected during shadowing. | cables are securely connected |
| Cables to expansion card(s) | to the expansion card(s). |
| If the problem persists, | |
| loose; faulty or improperly | |
| see "Troubleshooting | |
| installed expansion card(s). | |
| Expansion Cards" on | |
|
| |
|
| page 143. |
PCIe Training Error: Expected Link Width is x, Actual Link Width is y.
Faulty or improperly installed PCIe card in the specified slot.
Reseat the PCIe card in the specified slot number.
See "Troubleshooting Expansion Cards" on page 143. If the problem persists, see "Getting Help" on page 157.
Plug & Play | Error encountered in | Install the NVRAM_CLR |
Configuration | initializing PCIe device; | jumper in the clear position |
Error | faulty system board. | (pins 1 and 3) and reboot the |
|
| system. See Figure |
|
| jumper location. If the |
|
| problem persists, |
|
| see "Troubleshooting |
|
| Expansion Cards" on |
|
| page 143. |
About Your System
43