Table 1-2. System Messages (continued)
Message | Causes | Corrective Actions |
|
|
|
Warning! | Invalid memory | Ensure that the memory |
Unsupported | configuration. The system | modules are installed in a |
memory | will run but with | valid configuration. |
configuration | reduced functionality. | See "General Memory |
detected. |
| Module Installation |
The memory |
| Guidelines" on page 98. |
configuration is |
| If the problem persists, |
not optimal. |
| see "Troubleshooting System |
The recommended |
| Memory" on page 137. |
memory |
|
|
configuration |
|
|
is: <message> |
|
|
Write fault Write fault on selected drive
Faulty USB device, USB medium, optical drive assembly, hard drive, or
Replace the USB medium or device. Ensure that the USB, SATA backplane, or
SATA cables are properly connected. See "Troubleshooting a USB Device" on page 130, "Troubleshooting an Internal USB Key" on page 139, and "Troubleshooting a Hard Drive" on page 141.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary at support.dell.com/manuals.
50
About Your System