Disabling a Forgotten Password
The system's software security features include a system password and a setup password, which are discussed in detail in "Using the System Setup Program." The password jumper enables these password features or disables them and clears any password(s) currently in use.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions that came with the system.
1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening and Closing the System."
3Remove the jumper plug from the password jumper.
See Figure
4Close the system.
5Reconnect your system and peripherals to their electrical outlets, and turn on the system.
The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed. However, before you assign a new system and/or setup password, you must install the jumper plug.
NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system disables the new password(s) the next time it boots.
6Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7Open the system. See "Opening and Closing the System."
8Install the jumper plug on the password jumper.
9Lower the memory module shroud.
10Close the system.
11Reconnect your system and peripherals to their electrical outlets, and turn on the system.
12Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Assigning a System Password."
156
Jumpers and Connectors
