Dell NX200 owner manual Installing the Front Bezel Insert, Removing an EMI Filler Panel

Installing the Front Bezel Insert

NOTE: If you remove a drive from one or more of the front drive bays, replace the corresponding insert(s) on the front bezel.

1From the back of the bezel, align the insert tab with the corresponding notch on the bezel. Press the insert until the tab snaps into place.

See Figure 3-3.

2Replace the front bezel. See "Installing the Front Bezel" on page 76.

EMI Filler Panel

Depending on the configuration of your system, an electromagnetic interference (EMI) filler panel may be installed in one or more of

the 5.25-inch optical drive bays at the front of the system. EMI filler panels are essential for airflow efficiency and for EMI protection. To install an optical drive, the corresponding EMI filler panel must first be removed.

Removing an EMI Filler Panel

1Remove the front bezel. See "Removing the Front Bezel" on page 75.

2Remove the EMI filler panel out of the chassis by pulling firmly on the holes in the middle of the filler panel. See Figure 3-4.

Installing System Components

77