RCD739 (Eng.)(A5)
To clean the CD player:
Dust on the pickup lens can lead to erratic operation and interruption of the sound during play.
NOTE: Do not touch the surface of the pickup lens. Do not allow any liquids on the inside of the product.
lens blower(available at most camera stores)
TROUBLESHOOTING GUIDE
You experience a problem with this unit check the chart below before calling of service.
SYMPTOM | CAUSE | SOLUTION | |
CD Player will | • Wrong adapter being used |
| |
• AC adapter not connected |
| ||
Not turn on |
| ||
properly |
| ||
|
| ||
| • Disc inserted incorrectly | • Reinsert disc with label side | |
Disc will notPlay | • Defective compact disc | facing up | |
• CD compartment not closed | • Try another compact disc | ||
| • Moisture condensationon disc | • Close CD compartment | |
|
| • Wipe disc with soft cloth | |
Erratic CDplayback | • Dirty or defective disc | • Clean or replace disc | |
| • Headphone plug not inserted | • Reinsert headphone cord into | |
| property | headphone jack | |
No sound | • Volume control set to minimum | • Increase the volume | |
• Defective compact disc | • Try another compact disc | ||
| |||
| • FUNCTION is not set to the | • press FUNCTION SELECTOR | |
| • desired position | switch to the desired function | |
Noise or Sound | • Station not tuned properly for FM | • Retune FM broadcast station | |
distorted on radio |
|
|
CARE AND MAINTENANCE
CARING FOR COMPACT DISCS
---To keep the CD clean, handle it by its edge. Do not touch the surface.
---Do not stick paper or tape onto the CD
---Do not expose the CD to direct sunlight or heat sources such as holt air ducts. Do not leave the CD in a car parked under direct sunlight.
Cleaning the Unit
---To prevent fire or shock hazard , disconnect your unit from the AC power source when cleaning.
---The finish on your unit may be cleaned with a dust cloth and cared for as other furniture. Use caution when cleaning and wiping the plastic parts.
IMPORTANCE
To keep up the clock's operating, Remember to turn off the unit by sliding the SELECTOR switch A to AL.OFF position as the clock memory will be lost if you disconnect your unit from the AC power source.
- 8 -