TC972 english.qxd 4/13/2004 10:58 AM Page 11
Cordless Telephone Operation
Preparing for Use
Before you can use your cordless telephone, you must charge the Handset for 12 hours. Failure to do so will require recharging of the Battery Pack more often.
1.Place the Handset on the Base Unit for 12 hours.
2.After 12 hours, remove the Handset from the Base Unit.
NOTE: Depending on the frequency of use, once the Handset is fully charged, it remains functional for approximately 6 hours of continuous use and approximately 6 days when the Handset is off the Base Unit in standby mode.
Placing Calls
1.Press the TALK button. The Handset IN USE LED indicator and the Base Unit IN USE/CHARGE LED indicator will light up.
2.Listen for a dial tone.
3.Dial the phone number.
4.When you have finished your call, either press the TALK button or place the Handset on the Base Unit. The Handset IN USE LED indicator will turn off and the Base Unit IN USE/CHARGE LED will light up to indicate that the Handset is charging.
In Use
Low Batt
Flash | TALK |
Redial |
1 2 3
NOTES:
1.The Base Unit does not have a ringer and does not ring when receiving an incoming call.
2.If you are too far away from the Base Unit, the Handset emits “beep” sounds to warn you that the background noise level is too high for proper communication between the Handset and the Base Unit. When you hear this sound, you should move closer to the Base Unit to reduce the noise level. Otherwise, the call will automatically cut off.
Receiving Calls with the Handset off the Base Unit
1.When the phone rings, press the TALK button. The IN USE LED indicator will light up.
2.Start your conversation.
3.To end your conversation, either press the TALK button or place the Handset on the Base Unit. If you place the Handset on the Base Unit CHARGE CRADLE, you activate the automatic standby feature.
10
