2.4Hardware Installation

PCI configuration

The PCI cards are equipped with a plug and play PCI controller,

it can request base addresses and interrupts in accordance with the PCI standard. The system BIOS will install the system resource based on the PCI cards’ configuration registers and system parameters (which are set by system BIOS). Interrupt assignment and memory usage (I/O port locations) of the PCI cards can be assigned by system BIOS only. These system resource assignments are done on a board-by-board basis. It is not suggested to assign the system resource by any other methods.

PCI slot selection

The PCI card can be inserted to any PCI slot without any configuration for

system resource. Please note that the PCI system board and slot must provide bus-mastering capability to operate this board properly.

PCI Installation Procedures

1.

Turn off your computer

 

2.

Turn off all accessories (printer, modem, monitor, etc.) connected

to

 

your computer.

 

3.Remove the cover from your computer.

4.Set up jumpers on the PCI card.

5.Select a 32-bit PCI slot. PCI slots are shorter than ISA or EISA slots, and are usually white or ivory.

6.Before handling the PCI cards, discharge any static buildup on your body by touching the metal case of the computer. Hold the edge and do not touch the components.

7.Position the board into the PCI slot you selected.

8.Secure the card in place at the rear panel of the system.

Installation ∙ 11