Menu CONFIG=>INTERFACE=>SWAN=>NETWORK PROTOCOL=>IP
Parameter | Example |
| Your Application |
Active or Inactive | Active enables IP communication (IPX and |
| |
| Transparent Bridge are not used in this |
| |
| example). |
|
|
Interface Unnumbered/ | Numbered |
|
|
Numbered |
|
|
|
Primary IP Address | 0.0.0.0 (This number will be assigned by the |
| |
| Access Provider dynamically.) |
| |
Subnet Mask | 255.0.0.0 |
|
|
Secondary IP Address | 0.0.0.0 for none |
|
|
IP MTU | Use the preset value, 1500. | This determines |
|
| whether or not a given IP datagram is |
| |
| fragmented. |
|
|
NAT | Global Assigned because the IP address of |
| |
| the SWAN interface will be assigned |
| |
| dynamically. |
|
|
Enable Dynamic Local IP | Yes, because the IP address of the SWAN |
| |
Address | interface will be assigned dynamically. |
| |
Remote IP Address Type | Any |
|
|
Remote IP Address | 0.0.0.0 |
|
|
ICMP Port | Inactive |
|
|
Incoming Rule List Name | None, filters are not included in this example. |
| |
Outgoing Rule List Name | None, filters are not included in this example. |
| |
Routing of Broadcast | Inactive |
|
|
Messages |
|
|
|
FIGURE 4.4 SWAN NETWORK PROTOCOL (IP) MENU PARAMETERS
Chapter 4 - | 20 |
