STEP THREE
The network protocol parameters, shown in Figure 4.12, are similar to those for the Ethernet interface. Fill in the parameters for your network in the
Menu CONFIG=>INTERFACE=>SWAN=>NETWORK PROTOCOL=>IP
Parameter | Example |
| Your Application |
Active or Inactive | Active enables IP communication (IPX and |
| |
| Transparent Bridge are not used in this |
| |
| example). |
|
|
Interface Unnumbered/ | Numbered |
|
|
Numbered |
|
|
|
Primary IP Address | 200.240.230.2 |
|
|
Subnet Mask | 255.255.255.240 is the mask in the |
| |
| example. |
|
|
Secondary IP Address | 0.0.0.0 for none. |
|
|
IP MTU | Use the preset value, 1500. | This |
|
| determines whether or not a given IP |
| |
| datagram is fragmented. |
|
|
NAT | Global, because NAT is not being used in |
| |
| this example. |
|
|
ICMP Port | Inactive |
|
|
Incoming Rule List | None, filters are not included in this |
| |
| example. |
|
|
Outgoing Rule List Name | None, filters are not included in this |
| |
| example. |
|
|
Routing of Broadcast | Inactive |
|
|
Messages |
|
|
|
FIGURE 4.12 SWAN NETWORK PROTOCOL (IP) MENU PARAMETERS
Chapter 4 - | 28 |
