Cyclades PR2000 15 STATIC ROUTE MENU PARAMETERS, Parameter, Example, Your Application

Cyclades-PR2000

Menu CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE

Parameter	Example	Your Application
Destination IP Address	15.0.0.0
Subnet Mask	255.255.255.0
Gateway or Interface	gateway
Gateway IP Address	200.240.230.1
Metric	One -- number of routers between router
	being configured and the destination IP
	address.
Is This a Backup Route?	No
OSPF Advertises This	No
Static Route
	FIGURE 4.15 STATIC ROUTE MENU PARAMETERS

STEP SIX

Now that the parameters have been defined, enter into each menu described above, in the order presented (read chapter 3, Using Menus, if you have not done so already). Set the parameters in each menu according to the values you wrote in the figures above. Save the configuration to flash memory at each step when requested — configurations saved in run memory are erased when the router is turned off. If you saved part of the configuration to run memory for some reason, save to flash memory now using the menu option ADMIN =>WRITE CONFIGURATION =>TO FLASH. Be sure to change the superuser password using the menu option CONFIG =>SECURITY => USERS =>MODIFY. The user ID, super, can remain the same, but the password must be changed to avoid unauthorized access.

STEP SEVEN

The Ethernet interface can be tested as described in the troubleshooting appendix. The SWAN interface can be tested in a similar manner. At this point, you should create a backup of the configuration file (in binary) and print out a listing of the configuration.

Chapter 4 - Step-by-Step Instructions 31