CycleOps Club Pro 300PT service manual

Step 2: Attach Handlebars

B

C

A

Step 3: Seat Assembly

C

B

A

A. Insert the handlebar post into the head tube and tighten the 6mm pinch bolt or L-Handle.

B. Carefully slide the handlebar onto the handlebar post, ensuring that the cables are not twisted. Once the handlebar is in place, secure it with the quick-re- lease lever. The lever must be in the “Closed” position in order to safely use the IC.

C. Once the handlebar is properly installed, attach the plastic end cap with two of the included Phillips-head screws.

A. Open the quick-release lever and slide the seat clamp assembly onto the seat tube. The clamp should be pointing towards the front of the CycleOps IC. Slide the clamp assembly all the way forward to allow access to the clamp. The seat clamp assembly is secured to the seat post tube via a quick-release lever. Secure the mechanism by rotating the lever into the “Closed” position prior to using the IC.

B. To attach the saddle to the seat post clamp, use a 6mm Allen wrench. Make sure both rails of the saddle are properly seated in the clamp and tighten the 6mm Allen bolt. If desired, you can at- tach any standard bicycle saddle to the CycleOps Indoor Cycle. Be sure to tighten the saddle so that it is level and parallel to the floor for optimum comfort. Note: Seat may need to be retightened after first few uses. Retighten screw for the seat assembly as well as for the angle of the seat.

C. Once the Saddle is level and properly tightened in the clamp, attach the plastic end cap with two of the included screws.

D. In some instances, a shorter seat post is required for individu- als under five feet tall. You can replace the standard seat clamp mechanism with part # 16616. Contact Saris Cycling Group to order this part. Follow the instructions provided with that part for installation.

B

2