Replacing Brake Pads
The brake pads on the IC are made of a consumable felt material. Over time, the pads will wear out and need to be replaced. Follow these steps to replace your brake pads:
With a 5mm Allen wrench, loosen the cable holding wire on the right hand side brake arm.
Loosen the pinch bolt that holds the washers onto the post of the brake pad.
Remove old pads and hardware from the brake arms. Pay attention to the orienta- tion of the washers and spacers as you remove them.
Insert new brake pads and hardware exactly as they were positioned prior to removal.
Align brake pads (see page 7)and tighten pinch bolts.
Replacing Resistance Knob
Remove water bottle holder by removing the four screws that hold it on.
Loosen the right hand brass cable stop until you can remove the cable from the stop.
Using a
8
