Brake Adjustment
Aligning Brake Pads
When aligning the brake pads after replacement or after adjusting the flywheel, use the following guidelines for accurate alignment:
Ensure the pads sit parallel to the smooth part of the flywheel.
Ensure the top of the pad does not contact the flywheel above the smooth part of the flywheel.
Ensure the pad mimics the curvature of the flywheel. NOTE: Brake pads should always be touching the flywheel.
Cable adjustment (under bottle cage)
Proper adjustment of the cables on the sliding splitter should look like this (Fig 1) In the event you need to adjust the cables, use the following steps:
Fig 1
Release all cable tension in the handlebar resistance knob.
Using a
Using a set of pliers, grasp the end of the cable that needs adjustment. Loosen the brass set screw and slide it towards the top of the cable carrier.
Once the brass set screw is touching the Repeat on other side if necessary. top of the cable carrier, tighten it securely
onto the cable. | 7 |
|
