In the “Option TAB”, there is the Refresh Time function. This function helps you to refresh the time for monitoring the device. Choose 15 secs, 30 secs, 1 min, 2 min, and 5 min to select the time for monitoring.

In the “Help TAB”, there is About function, it will show out the version of the Web Management Utility.

Configuring the Switch

The Web Smart 48-Port 10/100/1000Mbps Gigabit Switch has a Web GUI interface for smart switch configuration. The Switch can be configured through the Web Browser. A network administrator can manage, control, and monitor the Switch from the local LAN. This section indicates how to configure the Switch to enable its smart functions including:

‹Port Setting (Speed/Disable and Flow Control)

‹Virtual LAN Group setting (VLAN)

‹Trunk

‹Port Mirroring

‹QoS

‹SNMP

‹Jumbo Frame

‹System Setting

‹Device status and Statistics

Login

Before you configure this device, note that when the Web Smart Switch is configured through an Ethernet connection, make sure the manager PC is set on same the IP network. For example, when the default network address of the default IP address of the Web Smart Switch is 192.168.0.1, then the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254), and the default subnet mask is 255.255.255.0.

Open Internet Explorer 5.0 or above Web browser.

Enter the IP address http://192.168.0.1 (the factory-default IP address setting) into the address location.

Figure 13.

18

Page 23
Image 23
D-Link DGS-1248T manual Configuring the Switch, Login