D-Link DHP-541 manual

Section 3 - Configuration

Plug the DHP-540 power cord into an electric outlet. Plug the other end of the power cord to the back of the device and then turn on the device by pushing the power switch to the ON position located on the back of the device. Power source is confirmed when the Power LED is illuminated.

Click Next to continue.

1.Connect the Ethernet cable from the LAN port to your computer’s Ethernet Port.

2.Please ensure that the LED in front of the device is on.

Click Next to continue.

D-Link DHP-541 User Manual

Page 15

Image 15

Contents

Page Trademarks Preface Table of Contents System Requirements Package Contents Introduction Features LEDs DHP-502AV Hardware Overview Connection DHP-540 Hardware Overview Power LED DHP-540 Hardware Overview Step Hardware InstallationNetwork Diagram Recommendations PowerLine Network Understanding PowerLine AV 500 Network SecurityPowerLine AV 500 4-Port Gigabit Switch DHP-540 PowerLine AV 500 Network Adapter DHP-502AV Using the Setup Wizard Configuration Page Page Page Page Configuration Click Finish to complete the installation Click the Advanced Settings icon Advanced Settings Device Info Network Info Diagnostics Understanding the Encryption Key setting Setting your private Encryption KeySecurity Adding a Device to your PowerLine Network Documentation ’m having a lot of problems configuring my network Troubleshooting DHP-540 Technical Specifications DHP-502AV Technical Specifications Contacting Technical Support Limited Warranty Warranty Limited Software Warranty Non-Applicability of WarrantySubmitting a Claim What Is Not Covered Trademarks Disclaimer of Other WarrantiesLimitation of Liability Governing Law FCC Statement CE Mark Warning Register your product at registration.dlink.com Registration