Step2： Close the joint edge of the router cover as shown in fig2 above
Step3： Drive the screws in and tighten them with the screwdriver
Step4： Reinstall the router on the rack or the table
Step5： After closing the router cover, you can connect all the cables
Upgrade System Memory
SDRAM Installation
This section describes how to upgrade the memory of
1.Turn OFF the power supply switch of
2.Follow the steps of “ Open the case” to take off the router cover
3.Refer to the following figure to find the location of SDRAM DIMM slot
Fig. 1
4.Release the locking spring clips on both sides of SDRAM DIMM with your thumbs carefully (as shown in Fig.2 below). When SDRAM springs out of its slots, you can pull out the original SDRAM vertically (as shown in Fig.2).
Note: If you cannot pull out the SDRAM, check if it is locked by any other object, and then follow the steps above to try again.
Fig.2
5.To insert new SDRAM into the SDRAM DIMM slot make the golden finger edge of the new SDRAM downwards as show in fig 2 above. Hold the top edge of the SDRAM with your forefingers and thumbs and insert it into the SDRAM DIMM slot vertically. The two notches of the SDRAM fit into the two bulges in the SDRAM DIMM slot (as shown in Fig.2).
6.Shut the locking spring clips on the both ends of SDRAM DIMM slot to fix the SDRAM (as shown in Fig.2)
7.You have finished the installation of SDRAM, please follow the steps of “ Close the case” as shown in Router Maintenance Section.
Upgrading FLASH Memory
The standard configuration of FLASH in
1.Turn OFF the power supply switch of
2.Follow the steps of “ Open the case” to take off the router cover
__________________________________________________________________________________________________________________
21
