D-Link DI-707P user manual Installation Requirements, Printer

Note:	The included power adapter is DC 5V/2A. Using the wrong type of
	power adapter may cause product damage.
Rear Panel

PRINTER	Parallel port connector (25-pins D-type female.) This is where you will
	connect the shared printer. (Optional)
COM	Serial port connector (9-pins D-type male.) This is where you can connect
	a back-up dial-up modem. This port is also a console port.
Broadband	WAN port socket (CAT5 Ethernet RJ-45 cable). This is where you will
	connect to your cable or DSL modem.
PORTS	LAN port sockets (CAT5 Ethernet RJ-45 cable.) The LED glows steadily
1-7	when a port is connected to a hub, switch or network -adapter-equipped
	computer in your local area network (LAN.)

Installation Requirements

The DI-707P can be positioned at any convenient place in your office or house. No special wiring or cooling requirements are needed. However, you should comply with the following guidelines:

•Place the DI-707P on a flat horizontal plane.

•Keep away from any heating devices.

•Do not place in a dusty or wet environment.

The recommended operational specifications of the DI-707P are:

Temperature	32o F	~	131o F
Humidity	5 %	~	90 %

In addition, remember to turn off the power, remove the power cord from the outlet, and keep your hands dry when you install the hardware.

-11-