D-Link DSL-302G manual Software Installation, Install the Modem Configuration Utility

Software Installation

In order to install the software driver for the Modem, you first need to install the DSL-300 Configuration Utility, D-Link’s GUI based management software. This software can later be used to monitor the device or change its settings. Install the Configuration Utility software on the PC directly connected to the device via either the Ethernet or USB interface.

In order to install the Configuration Utility on a computer using the USB interface, two additional drivers must be installed. A special USB driver and an Ethernet client driver must first be installed on the computer. It is then necessary to configure the Ethernet client driver. Read the instructions in the section titled USB Driver if you are configuring the Modem using the USB interface.

Install the Modem Configuration Utility

Install the Configuration Utility software by inserting the setup CD-ROM disc into your CD-ROM drive and wait for the following screen prompts to appear:

1.The Setup window informs you that it is preparing the “InstallShield Wizard”.

2.The Welcome window recommends exiting all other programs before starting the setup procedure. If you do not wish to close other programs click Cancel, otherwise quit all other programs and click Next.