2
Hardware Installation
The
The Router can be placed on a shelf or desktop, ideally you should be able to see the LED indicators on the front if you need to view them for troubleshooting. To conserve desktop space, the Router is shipped with plastic feet that can be snapped into place to support it. The Front and Rear panel views presented above show the device mounted using the plastic feet.
Power on Router
CAUTION: The Router must be used with the power adapter included with the device.
To power on the Router:
1.Connect the power adapter shipped with the Router to the power recepticle on the back panel of the device.
2.Plug the power adapter to an suitable electrical wall outlet or power strip.
3.Toggle the power switch on the back panel to power on the Router. The Power LED on the front of the Router will light green indicating it is powered on.
Factory Reset Button
The Router may be reset to the original factory default settings by depressing the reset button for a few seconds while the device is powered on. Use a ballpoint pen or paperclip to gently push down the reset button. Hold the reset button down until the Status light goes dark. Remember that this will wipe out any settings stored in flash memory including user account information and LAN IP settings. The factory default IP address of the Router is 10.1.1.1 and the subnet mask is 255.0.0.0, the default management Username is admin and the default Password is admin.
6
