DVG-5112S User’s Manual

Select a PPPoE

After entering IVR mode, dial 114.

After hearing “Enter value,” dial 3 (to select PPPoE).

PPPoE Account Settings

After entering IVR mode, dial 121.

After hearing “Enter value”, enter the account number followed by”#”.

Example: If the account is “84943122@hinet.net,” please enter 0804090403010202714849544560725445 60#.

NOTE: it is necessary to enter two digits for each character/number; for example, you must enter “01” for “1” and “11” for “A”. It is recommended that you use the web Interface to configure your PPPoE account details. Refer to the PPPoE Character Conversion Table on the next page for key mappings if you choose to use IVR setup.

PPPoE Password Setting

After entering IVR mode, dial 122,

After hearing “Enter value,” enter the new password followed by “#”.

Example: If the password is “3ttixike”, please enter “03 60 60 49 64 49 51 45#”.

Save Settings and Restart

To save settings, dial 509 (Save Settings). The system will save the settings. Please restart the system. Wait for about 40 seconds for the system to restart, then enter 101 to check whether or not the IP address was retained. If the IP address is not repeated, this indicates that the gateway is not properly connected. Please check to be certain that the cable connection, account, and password are all correct.

.

D-Link Systems, Inc.

51