D-Link DWL-610 Ad-Hoc Channel Advanced, Profile IP Settings, Power Mode, Data Packet Parameter

Using the Configuration Utility (continued)

Ad-Hoc Channel: Advanced

All devices in the Ad Hoc network must be set to the same channel

Profile IP Settings:

You can Enable or Disable the IP Settings portion of your profile here. If you select Disable you will need to configure the IP Address information each time you connect to a network. If you select Enable you will maintain the same IP Address information each time you connect to a network.

Power Mode:

Disable -this default setting consumes the most power

Enable - this setting consumes the least power

Launch Utility on Startup:

Select Enable or Disable

Data Packet Parameter:

Select the parameters here

Fragmentation Threshold:

This value should remain at its default setting of 2432. If you experience a high packet error rate, you may slightly increase your Fragmentation Threshold within the value range of 256 to 2432. Setting the Fragmentation Threshold too low may result in poor performance.

RTS Threshold:

This value should remain at its default setting of 2432. If inconsistent data flow is a problem, only a minor modification should be made.

Click Apply if you have made any changes

14