Dacor PD, 24GN Plumbing Connections, Installing the Unit in the Cabinet, Level the Dishwasher

Installation Instructions

Plumbing Connections

1.Connect one end of the 3/8” flexible braided fill hose to the water supply valve.

2.Route the hose through the utility access hole in the side of the appliance cut-out. Put the unconnected end of the hose over a bucket. Turn on the water to clean any debris out of the supply line and fill the hose for leak testing. Turn the valve off.

3.Keeping as much water as possible in the hose, route it through the bottom of the dishwasher chassis and connect it to the water inlet. Access the water inlet through the hole on the left side of the chassis.

Fill hose Water inlet Access hole in side

Dishwasher Left Side

4.Turn on the water valve and check both ends for leaks.

5.Using the included plastic fasteners, attach the left side access panel. NOTE: The top edge of the access panel slides behind the chassis corner as shown below.

Chassis

corner

Installing the Unit in the Cabinet

•Make sure the water valve is off before sliding the unit into the cabinet.

•Care should be exercised when the appliance is installed or removed to reduce the likelihood of damage to the power cord or hoses.

•Before sliding the unit into the cut-out, make sure the hoses and wiring are positioned in the utility cut-outs as shown on the facing page.

Level the Dishwasher

Level the dishwasher using the adjustable legs on the front and back before sliding the unit into the cut-out.

1.Measure the height of the front and back of the cut-out with a tape measure.

2.Measure the height of of the front and back of the dishwasher.

3.Using a crescent wrench, loosen the leg nut on all four legs and turn the legs to adjust them. The maximum height of the dishwasher must be 1/8” lower than the maximum height of the cut-out.

Leg nut	Leg
	nut
Front	Rear
leg	leg

4.Remove the lower rack from the dishwasher and place a level on the tank side wall rack guides to verify the unit is level front to back. To verify left to right level, place a level on the front door jamb.

5.Adjust the legs until the unit is level and does not exceed the height specifications in step 3.

6.Tighten the leg nut to the chassis to secure the leg in place.

NOTE: The leg nuts can be removed to make the dishwasher lower. See page 10.

Access panel	Slide this edge behind
	chassis corner

6.Slide the drain hose into the utility access hole in the side of the appliance cut-out. See facing page.

9