Dacor 24GN Cabinet Panel Installation Model ID24 Only, continued, Install the Anti-Tip Brackets

Installation Instructions

Installing the Unit in the Cabinet

(continued)

NOTE: The leg nuts can be removed to make the dishwasher lower. To do so:

•Turn the leg until it comes out of the chassis.

•Remove the nut from the leg.

•Re-thread the leg into the chassis.

•Reach inside the chassis and thread the nut onto the top of the leg.

2.To attach the anti-tip bracket anchors, insert the anchoring screws through the 1/2” diameter access holes inside the dishwashing compartment on the ceiling and the sides, near the front. Make sure that the anchoring screws pass through the anti-tip brackets located on the outside of the dishwasher.

 





Slide the Dishwasher into the Cutout

•Pull the electrical wiring and both hoses (drain and water supply) through the utility access hole in the side of the cabinet as you slide the dishwasher into the opening. Stop when the dishwasher contacts the back wall or aligns with the front cabinet opening.

Install the Anti-Tip Brackets

Top anti-tip

bracket

Side anti-tip

bracket

Cabinet Panel Installation (Model ID24 Only)

Install the custom panel and/or custom toe kick according to the instructions on the included template (Dacor PN 101934). If the panel requires decorative door hardware, attach it before panel installation.

CAUTION

•To prevent corrosion and the possibility of the panel falling off, use only stainless steel screws where instructed.

•The provided mounting screws are designed for panels with a thickness of 5/8” to 3/4”. Smaller panels may require different mounting hardware to prevent damage to the outside surface.

•Failure to construct the custom panel and/or toe kick as instructed on the template may result an improper fit and may prevent the door from closing properly.

CAUTION

•Make sure to anchor at least one anti-tip bracket on each side of the dishwasher.

•The anchoring material must be no more than 1/4” (6mm) from the anti-tip bracket.

The anti-tip brackets protect against possible tipping caused by heavy bottom rack loads on the door.

1.There are anti-tip mounting locations provided around the top and sides of the dishwasher front frame.

CUSTOM PANEL INSTALLATION (ID24 ONLY)

10